Investigation of Roll Shift Schedule for WRS Mill and Rolls Deflections

WRS轧机工作辊横移方案及辊系变形研究

Where required, to examine deflections , stiffness requirements, and any special material and design provisions to obviate brittle fracture under adverse conditions.

必要时验算挠度、刚度要求、以及任一特殊材料和设计规定，以预防不利条件下的脆断。

The effects of deflections are evaluated during the process of calibrating the balance

变形影响是在天平校准的过程中测量的。

Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections

垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度，来承担足够的荷载。

but the deflections of the road increase this distance by more than a third

但是，全线实际的长度却至少增加了三分之一，这是由于铁路路线向北延伸要经过半岛北部的阿拉哈巴德的缘故。

Study on Determination of Stress Level by Seismic Stress Drops and the Stress Axis Deflections Before and After Large Earthquakes

根据大地震前后应力轴偏转和应力降求取应力量值的研究

General Expression for determining Deflections of the Stepped Shaft in Bending

阶梯轴弯曲变形的普遍表达式

Using Inclinometers to Measure Bridge Deflections

利用倾角仪测量桥梁的挠度

Estimating Deflections of Wood Shear Walls Sheathed on Both Sides

两侧有覆面板的木结构剪力墙侧向变形计算

Test Method for Deflections with a Falling-Weight-Type Impulse Load Device

落重型脉冲负荷装置挠曲的试验方法

They observed the deflections of the particles by allowing them to fall on a fluorescent screen

他们让粒子落在荧光屏上以观察他们的偏移。

Computation of Steady and Unsteady Transonic Flowfor a Wing with Control Surface Deflections

跨音速机翼操纵面定常、非定常气动力计算

Qualitative analysis on the Measurement Errors of Pole’s Deflections with Two Testing Methods

两种电杆挠度检验方法测量误差的定性分析探讨

Important Influence of Deflections on the Burst Pressure of Pre-Bulged Radial Slot Rupture Discs

预拱挠度对透缝爆破片破裂压力的影响

Both fatigue and shock loads must be considered in obtaining the stresses and deflections of the various portions of positive clutches.

在求解刚性离合器各个部分的应力和疲劳时，疲劳和冲击载荷必须被考虑。